Publicidad
Safety warnings for
blowers
Before operating the blower
DANGER
• Never operate the tool when you are
tired, ill, or under the influence of drugs, alcohol or
medication.
• Wear appropriate clothing to operate the tool: tight
fitting clothing, heavy pants, non-skid safety boots,
heavy-duty protective gloves, hearing protection, and
safety glasses with side shields per ANSI Z87.1, as well as a
dust mask or face shield to prevent breathing in harmful
debris.
WARNING
• Remove any loose clothing or
accessories that could be caught in the motor. Pull your
hair back so that it is above shoulder level.
• Make sure the tool is in perfect condition. Do not start if
it is improperly adjusted or not fully assembled so that it
will operate safely.
• Make sure the tool is clean, dry and free of oil.
• Make sure the work area is in an open, well-ventilated
area.
• In extreme temperatures check for ice formation or
condensation on the tool.
• Ensure that visibility and light conditions are adequate to
see clearly, otherwise do not use the tool.
When operating the blower
WARNING
• Make sure the nozzle is not pointed
at any person or animal before starting the engine. Never
point the blower at people or animals.
• Hold the blower properly and with both feet firmly on the
ground.
• Keep the tool away from flammable materials.
• Do not attempt to make adjustments to the tool with the
motor running.
• Do not attempt to remove material clogged inside the
tubes or blower with the motor running. Switch off before
removing material.
• Be aware of hazards in your environment, the noise of
the tool may prevent you from noticing them.
After operating the blower
WARNING
• Shut off the motor before idling the
tool. DO NOT leave the engine running unattended.
WARNING
• Do not leave the blower with the
engine running on dirty surfaces or on grass, as it could
pick up debris that may later be thrown at the operator or
others, causing serious injury.
CAUTION
• Service and repair of the tool should
only be performed by a
Service Center.
Assembly recommendations
WARNING
• If parts are missing, do not operate
the tool until they are replaced. Failure to do so may
result in serious personal injury.
WARNING
• Do not attempt to modify the tool or
fabricate accessories not recommended for the tool.
Failure to do so may result in injury and may invalidate
the warranty.
Authorized
ENGLISH
5
Publicidad
