Publicidad
Start up
Configurations
• To configure the equipment as a blower (1) or as a vacuum cleaner (2), turn the output / input port (3) until one of the
symbols is at the top of the port.
• When configuring the unit as a vacuum cleaner, connect the collecting bag to the air outlet.
CAUTION
• When configuring the unit as a blower, do not attach the collecting bag.
1
2
Blower
Vacuum cleaner
3
C
Power on
• Connect the end of an extension cord to the power
cord of the blower.
B
• Stretch the extension cord tightly.
• Connect the extension cord to an outlet that has the
voltage specified on the blower.
• To turn the equipment on: press the switch (A) to start
the equipment.
To interrupt use, release the switch.
• If you wish to operate the machine continuously, press
the lock button (B) while holding down the triggers (A).
This allows you to release the trigger pressure while
A
working.
• The tool can be operated at 7 different speed levels
which can be selected with the speed control knob (C).
Operation
Blowing
Waist
rotation
• With both feet firmly on the ground and your body
well balanced, hold the equipment by the handle.
• With the blower nozzle pointing down and away from
your feet, turn on the equipment.
• Make side-to-side motions by turning at the waist so
that the air expelled from the nozzle pushes the debris to
be swept.
• Push the debris into a pile.
• To avoid scattering the debris in the pile, blow around
the outer edges of the debris pile. Do not blow toward
the center of the pile.
• To reduce noise levels, limit the number of blowers
used at the same time.
Vacuuming
• Use the blower at reasonable times to avoid disturbing
others with noise.
• After using the blower, dispose of the waste properly.
• If the equipment is used as a vacuum cleaner, install
the collecting bag and hose between the inlet port and
the vacuum nozzle.
ENGLISH
7
Publicidad
