Bi-Wire Connection; Connecting Speaker Cables; Connecting Power Cable - Yamaha A-S201 Manual De Instrucciones

■ REC jacks
• The REC jacks output audio signals of the currently
selected input (except when LINE 2 is selected).
• Volume level, tone control, balance and Pure Direct
settings do not affect the REC jacks.

■ Connecting speaker cables

1 Remove approximately 10 mm of insulation from the
end of each speaker cable.
2 Twist the bare wires of the cable firmly together.
3 Unscrew the knob.
4 Insert one bare wire into the hole in the side of each
terminal.
5 Tighten the knob to secure the wire.
Red: positive (+)
Black: negative (–)
■ Connecting via banana plug
(Except for Asia, U.K. and Europe
models)
1 Tighten the knob.
2 Insert the banana plug into the end of the
corresponding terminal.
Banana plug
CAUTION
Speaker impedance must be set as shown below.
Speaker connection
SPEAKERS A or
SPEAKERS B
SPEAKERS A and
SPEAKERS B
Bi-wiring
Speaker impedance
8 Ω or higher
16 Ω or higher
(except for North
America model)
8 Ω or higher

■ Bi-wire connection

Bi-wire connection separates the woofer from the
combined midrange and tweeter section.
A bi-wire compatible speaker has four binding post
terminals. These two sets of terminals allow the speaker to
be split into two independent sections. With these
connections, the mid and high frequency drivers are
connected to one set of terminals and the low frequency
driver to another set of terminals.
Rear panel
Connect the other speaker to the other set of terminals in
the same way.
Note
When making bi-wire connections, remove the shorting bridges
or cables on the speaker.
y
To use the bi-wire connections, press SPEAKERS A and
SPEAKERS B on the front panel so that both SP A and B light up
on the front panel display.

Connecting power cable

Plug the power cable into an AC wall outlet after all other
connections are complete.
CAUTION
Only for General model:
Before connecting the power cable, make sure you set
VOLTAGE SELECTOR of this unit according to your
local voltage. Improper setting of VOLTAGE SELECTOR
may cause fire and damage to this unit.
CONNECTIONS
Speaker
To the AC wall
outlet with the
power cable
9
En