Chapter 9 - Checks Before Start Up; Chapter 10 - Starting And Stopping - Lavorwash SWL 990 ET Manual De Instrucciones

CHAPTER 9 - CHECKS BEFORE START UP

1 . Check the level of the battery solution and if necessary
top up with distilled water .
2 . Make sure the connector Part. 1 Fig. 13 is well inserted
in the socket Part. 2 Fig. 13 ..

Read carefully the Engine User Manual attached to this machine booklet and follow some simple instructions:
1 . Check the level of oil in the engine and
top up, if low, wearing protection gloves (
possibly nitrile gloves with cotton inside)
the oil sump (from 5,5 hp-3,75 kw) contains
about 5hg of oil . The recommended oil for
temperate climate is 10w-30 . To protect
engine a particular device stops the engine
by switching on if oil is absent or not enough;
it is therefore necessary checking the oil level
very often .
2 . Refuel with switched off and cold engine only;
Unlead petrol is strongly advised .
ATTENTION:
KEEP FUEL OUT OF CHILDREN'S REACH , IN A DRY AND AIRY PLACE, FAR FROM HEAT
SOURCES E AERATO, LONTANO DA FONTI DI CALORE.
IMPORTANT: Fuel tank must be fit for the purpose and well cleaned. This will grant you a good and
long lasting of the petrol engine filter. Please use a tank suitable to use up fuel in max 2/3 months
in order to have fresh fuel all the time.

CHAPTER 10 - STARTING AND STOPPING

ATTENTION PLEASE:
BEFORE PROCEEDING MAKE SURE YOU HAVE READ ALL PREVIOUS CHAPTERS.
IMPORTANT: To start the machine, first of all sit in the driver's seat. If the operator is not sat, or if
he/she stands up during start up, the machine will stop.
START UP :
•
Turn the key Part. 6 of switchboard clockwise
•
Turn the switch Part. 5 of switchboard to start the engine, the rotation of brushes and to activate
suction .
The machine is in working position with the central brush lowered and suction engaged.
MODEL SWL-R 990 ET (battery model)
MODEL SWL-R 990 ST (engine model)
MODEL SWL-R 990 ET (battery model)
28