General Information; Tools And Materials; Component Locations; Specifications - Dometic PS250 Manual De Instalacion Y Uso

General Information

• Incorrect maintenance or use of spare parts
other than original spare parts provided by the
manufacturer
• Alterations to the product without express permission
from the manufacturer
• Use for purposes other than those described in this
manual
Dometic reserves the right to change product
appearance and product specifications.
3 General Information
The images used in this document are for reference
I
purposes only. Components and component
locations may vary according to specific product
models. Measurements may vary ±0.38 in. (10 mm).

3.1 Tools and Materials

Dometic recommends that the following tools and
materials be used while installing the appliance.
Recommended Tools and Materials
5/16 in. (8 mm) Socket
Wrench
Phillips-head Screwdriver
Wire Strippers and Crimper
8
Water-tight Connections
and/or Junction Box
Other hardware sufficient for
secure mounting at desired
location

3.2 Component Locations

For component locations, see Figure 1 for PS250,
Figure 2 for PS500, and Figure 3 for PS1000.
Legend for all models:
Motor Assembly
q
Mounting Grommets
w
Mounting Base
e
Mounting Base Screw
r
Rear Housing Barrier
t
O-Ring
Motor Cooling Tube
y
Seal
Rear Pump Housing
u

4 Specifications

The pump has a sealed motor casing and can function
while completely submersed or when placed in a damp
area, like a bilge.
The major pump parts are glass-filled polypropylene for
superior corrosion resistance.
For best performance, maintain operation of
I
this pump within the following specifications.
Additional specifications for each pump are
available online at www.dometic.com.

4.1 Maximum Surface Temperature

The maximum allowable surface temperature of the
pump is 180 °F (82 °C).

4.2 Flow Rate

For maximum and minimum flow rates, see Figure 4 for
PS250, Figure 5 for PS500, and Figure 6 for PS1000.
Legend for all models:
Head Ft (M)
q
For additional information, see the following tables.
Submersible Pump
Front Cover O-Ring
i
Impeller Assembly
o
Rubber Cap
a
Ceramic Thrust Washer
s
Impeller Shaft
d
Front Cover
f
Front Cover Screw
g
Wet End Assembly
h
Mounting Base Kit
j
Flow Gpm (Lpm)
w
EN