Publicidad
Idiomas disponibles
Idiomas disponibles
The appliance must always be stored and
transported in an upright position.
If in doubt, we recommend that you wait at
least 24 hours before switching the
hours before switching the unit on again.
Installation
•
To save energy and ensure optimal performance of the appliance, please close all doors and windows in the
room.
Please place the appliance on a flat level surface.
•
To avoid loud noises and vibrations, you can place a small carpet or rubber mat under the unit.
•
Parts (1)
1
Water Tank
2
Water tank handle
3
Water tank cover
4
Control panel
5
Front
6
Back Cover
Control Panel (2)
1
Timer button
2
Inner drying button
3
Fan speed button
4
Tank full indicator
Functions
On/off:
•
Please plug in the unit.
Please make sure that the water tank is empty before switching on.
•
Please press the On/Off button (8) to switch the unit on or off.
•
The device automatically starts with the previous setting when it is started from standby mode. If you have
•
disconnected the power plug or the unit has performed internal drying, please press the mode key (7) to
select the mode.
Mode:
•
After switching on the unit, please press the mode button (7) to select between automatic and continuous
dehumidification. The corresponding indication light lights up.
Automatic dehumidification:
•
Please press the mode button (7) to switch on the automatic dehumidification function; the corresponding
indicator lights up.
The desired humidity level can be set between 30% and 80% in 5% steps by pressing the humidity level
•
button (6).
Press the fan speed button (3) to select between high and low wind speed.
•
If the ambient humidity is 5% lower than the set humidity level, only the fan function will be activated. As
•
soon as the room humidity gets 5% higher than the set value, the compressor will start automatically.
Continuous dehumidification:
•
Please press the mode button (7) to switch on the continuous dehumidification function. This mode can be
used without regard to the ambient humidity level. To select between high and low fan speed, please press
the fan speed button (3). The humidity level cannot be set in this mode.
Important:
7
Handle
8
Dust and activated carbon filter
9
Drainage hole with lid and
10
Power cord mount
11
Wheels
5
LED display
6
Humidity level button
7
Mode button
8
On/Off button
Publicidad
