Battery Replacement - Keysight Technologies U1701B Guía Del Usuario Y Servicios

Battery Replacement

Remove all test leads and external adaptor before opening the case.
WARNING
To avoid instruments being damage from battery leakage:
CAUTION
– Always remove dead batteries immediately.
– Always remove the battery and store it separately if the meter is not going
The meter is powered by 9 V battery, ensure that only the specified battery is
used. You are required to replace the battery immediately when the
annunciator is flashing. To replace the battery, refer to the following procedures:
1 Remove alligator clip leads and power-off the meter.
2 Unscrew the screw on the battery cover (see
3 Slide down the battery cover and remove the cover.
4 Replace the battery with a specified 9 V battery.
5 Reverse the procedure step 3 and 4 to close the bottom cover.
Keysight U1701B User's and Service Guide
to be used for a long period.
Battery Type
Alkaline
Service and Maintenance
Figure 4-1).
ANSI/NEDA
1604A
4
IEC
6LR61
61