Descargar Imprimir esta página

SodaStream SPIRIT Guía De Usuario página 6

Publicidad

Idiomas disponibles

Idiomas disponibles

CREATE THE BUBBLES
1. Fill the Plastic Carbonating Bottle with cold water up to the fill line.
WARNING! Do not carbonate anything other than water. Other
liquids can contaminate and clog internal parts, potentially
resulting in excessive pressure, bottle failure during carbonation
and serious injury. Never carbonate after flavoring has been
added.
2. To insert the Plastic Carbonating Bottle, make sure that the
Carbonating Bottle rest is angled forward. Please make sure you do
not pull the carbonating tube. WARNING! Never use a Sparkling
Water Maker with a broken carbonating tube. This can cause
excessive pressure, bottle failure and serious injury. Insert the Plastic
Carbonating Bottle neck into the Snap-Lock. Push the Plastic
Carbonating Bottle up and back. The Snap-Lock will hold the Plastic
Carbonating Bottle.
3. To carbonate, press the Plastic Carbonating Bottle in short 1 second
presses; 3 presses for standard carbonation and 5 presses for strong
carbonation.
4. When the desired level of carbonation is achieved, gently pull the
Plastic Carbonating Bottle towards you until it reaches its fully forward
position. This will release the pressure in the Plastic Carbonating Bottle
and allow the Plastic Carbonating Bottle to be released from the
Snap-Lock. WARNING! Do not remove Plastic Carbonating Bottle
until after hearing the sound of excess CO
force the Plastic Carbonating Bottle out of the Snap-Lock. Always
allow the Sparkling Water Maker to release the Plastic Carbonating
Bottle. If the Plastic Carbonating Bottle does not immediately release
from the Snap-Lock wait a few moments. If it still does not release,
then push the Plastic Carbonating Bottle back into the vertical position
and gently pull it towards you again. Attempting to remove the
Plastic Carbonating Bottle while it is still pressurized can cause
uncontrolled ejection of the Plastic Carbonating Bottle and may
result in serious injury.
CARE
SPARKLING WATER MAKER CARE
• Never use abrasive cleaners or sharp tools to clean. If needed, use a mild liquid dish soap and a soft
damp cloth to gently clean.
• Wipe spills to keep base dry.
• Do not place in water or wash in a dishwasher, doing so will seriously damage your Sparkling Water
Maker.
PLASTIC CARBONATING BOTTLE CARE
• For Plastic Carbonating Bottles which are not "dishwasher safe", to clean, rinse Plastic Carbonating
Bottles with cold or lukewarm water. WARNING! Do not expose to heat above 120°F / 50°C. Never
wash or rinse in hot water. Do not wash in dishwasher.
• For "dishwasher safe" Plastic Carbonating Bottles, to clean, either wash in dishwasher or rinse Plastic
Carbonating Bottles with cold or lukewarm water. WARNING! Do not expose to heat above 158°F / 70°C.
being released. Never
2
1
2
A
Note: when inserted correctly, there is a small
gap between the bottom of the Plastic
Carbonating Bottle and the base. Do not
carbonate if the Plastic Carbonating Bottle is
resting on the base, or water will splash out.
3
X
5
X
3
Note: You may see
small pieces of ice
appear in the water
during carbonation of
very cold water. Any
ice created will simply
melt.
4
1 6
C
B

Publicidad

loading

Este manual también es adecuado para:

Fizzi