Quick Start; Indicator Lights - HORIZON 6FA RegenLab Manual De Instrucciones

Q S
UICK TART
The LED indicator light is on for the cycle currently
(1) 5 Min
(2) 9 Min
(3) 30 Min

Indicator Lights

Start
Unlock
Stop
Cycle Selection
Lock Cycle Selection
Unlock Cycle Selection
selected:
This setting is factory preset to 3500 RPMs @1500xg for 5 minutes.
This setting is factory preset to 3500 RPMs @1500xg for 9 minutes.
This setting is factory preset to 3500 RPMs @1500xg for 30 minutes.
Begins running the cycle indicated by the cycle indicator LED light.
The lid must be closed.
Allows access into the rotor chamber by engaging the unlocking
mechanism. Entry is only possible when the rotor is stopped.
Pressing the UNLOCK button during operation will terminate the run
and unlock the lid after the rotor has come to a stop.
The LED light is on for the cycle currently selected. To change the
selected cycle, press the UNLOCK button in succession until the
desired cycle is selected. Two seconds after selection, the button
reverts to its UNLOCK function.
Select desired cycle. Press and hold the UNLOCK button for 5
seconds. Two beeps will confirm that cycle selection is locked.
To re-enable cycle selection, press and hold the UNLOCK button for
5 seconds. Three beeps will confirm that cycle selection is now
unlocked.
RegenLab SA – Customer Service: +41 (0)21 864 0111 | Page 4