Main Parts Of The Product; Preparation Before Use; Cleaning & Maintenance - Hendi 211403 Manual Del Usuario

This appliance is fitted with a power cord with grounding plug
or electrical connections with grounding wire. The connections
must be properly installed and grounded.

Main parts of the product

(Fig.1 on page 3)
1. ON/OFF switch
2. Dry boiling protection indicator (Orange) / Heating indica-
tor (Green)
3. Drain tap
4. Lever
5. Liquid level indicator
6. Lift up handle
7. Steam vent
8. Lid cover handle
9. Lid cover
10. Container
11. Temperature dial
12. Drip tray
Remark: The content of this manual applies for all listed items
unless specified otherwise. The appearance may vary from the
shown illustrations.

Preparation before use

• Remove all protective packaging and wrapping.
• Check that the device is in good condition and with all ac-
cessories. In case of incomplete or damaged delivery, please
contact the supplier immediately. In this case, do not use the
device.
• Clean the accessories and the appliance before use (See ==>
Cleaning & Maintenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and heat resistant
surface that is safe against water splashes.
• Keep the packaging if you intend to store your appliance in
the future.
• Keep the user manual for future reference.
NOTE! Due to manufacturing residues, the appliance may emit
a light odor during the first few uses. This is normal and does
not indicate any defect or hazard. Make sure the appliance is
well ventilated.
Operating instructions
(Fig.1 on page 3)
• Make sure the tap is closed.
• Fill the appliance with beverage up to the MAX level indicated
on the liquid level indicator (5).
• Close the boiler with the lid.
• Switch the appliance on by setting the switch to position I. The
ON/OFF switch (1) will light on in green colour.
• Use the temperature dial (11) to select the desired temper-
ature (maximum temperature setting is 110 °C). The actual
temperature can differ from the selected temperature.
• When heating is in progress no light on the heating indicator
(2) will be indicated.
• When the beverage has reached the selected temperature,
the heating indicator (2) will light on in green colour.
• When dry boiling protection is activated or the boiler is too
hot, the dry boiling protection indicator (2) will light on in or-
ange colour. Unplug it & let it cool down completely for 15 ~
20 minutes. Then, plug it and restart again.
After use / Empty the boiler
• Turn off the appliance by switching off the switch and remov-
ing the plug from the socket.
• Place a drip tray under the tap.
• Open the tap and drain the beverage out of the boiler.
• When the boiler has been emptied, close the tap.
Cleaning & maintenance
• ATTENTION! Always disconnect the appliance from the pow-
er supply and cool down before storage, cleaning & mainte-
nance.
• Do not use water jet or steam cleaner for cleaning and do not
push the appliance under the water as the parts will get wet
and electric shock might be resulted.
• If the appliance is not kept in a good state of cleanliness, this
can adversely affect the life of the appliance and result in a
dangerous situation.
Cleaning
• Clean the cooled exterior surface with a cloth or sponge
slightly dampened with a mild soap solution.
• For reasons of hygiene, the appliance should be cleaned be-
fore and after use.
• Avoid water contacting the electrical components.
• Never immerse the appliance in water or other liquids.
• Never use aggressive cleaning agents, abrasive sponges, or
cleaning agents containing chlorine. Do not use steel wool,
metallic utensils, or any sharp or pointed objects for cleaning.
Do not use petrol or solvents!
• When you drain off beverage or dirty water, leave the tap open
and rinse the boiler with clean water.
• Clean and descale the boiler base at regular intervals (see
chapter "Descaling").
• No parts are dishwasher safe.
Maintenance
• Check the operation of the appliance regularly to prevent se-
rious accidents.
• If you see that the appliance is not working properly or that
there is a problem, stop using it, switch it off and contact the
supplier.
• All maintenance, installation and repair work must be car-
ried out by specialised and authorised technicians, or recom-
mended by the manufacturer.
Transportation and Storage
• Before storage, always make sure that the appliance has
been disconnected from the power supply and completely
cooled down.
• Store the appliance in a cool, clean and dry place.
• Never place heavy objects on the appliance as this could
damage it.
• Do not move the appliance while it is under operation. Dis-
connect the appliance from power supply when moving and
hold it at the bottom.
GB
7