Publicidad
Idiomas disponibles
Idiomas disponibles
To perform the updating, follow the steps below.
1. Prepare the SD memory card
2. Before you use the SD memory card, you should format it to "FAT16 (default)"
3. After formatting your SD card, copy the new software file received from
Continental Automotive Trading Italia
4. Turn off the Control Box
5. Put your SD memory card into the SD slot of back side of the Control Box
SD Memory
Card Slot
SD_CARD
6. Turn on the Control Box. You can see the message "WRITING SOFTWARE" in
LCD Display.
7. If you see the message "FINISH TO WRITE", the Control Box is finishing the
software upgrade. You have to wait until the Control Box is restarted
8. Turn off the Control Box. Take your SD memory card away from the slot.
9. Turn on the Control Box
Figure C-1
SD memory card
RS-232
RECEIVER
Figure C-2
The back of the IDU
Satellite Antennas User Manual ver. 2.0
ANTENNA
12~24VDC
IN
DC
OUT
65
Publicidad
