Descargar Imprimir esta página

Zepter EdelWasser PWC-670-BLACK Manual De Instrucciones página 6

Ocultar thumbs Ver también para EdelWasser PWC-670-BLACK:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 25
EN
Be cautious!
• Water filtration device installation place 1
Please install the water filtration system not at a
rough place, a damp place, a place where the
unit is exposed to the direct sunlight, a place
where dust is present, or a place that the water
drops.
• Water filtration device installation place 2
Please install at the place where it is 10 cm or
more off from the wall and the bottom is flat and
firm.
• After installing the water filtration
system
Please empty the water tank filled with filtered
water two times after the product installation.
• Cold water plumbing
Please connect the source water. Make sure that
the source water is not from hot water line.
If you use hot water as source water, then it will
cause permanent damages to RO membrane and
severely degrade the product performance.
Tips
- There may be some water remaining inside of the filter which was used to
test the product during inspection process at the factory.
Please feel at ease and use as it isn't a used product.
- Don't reuse the main water supply valve and hose that was previously
used when you re-install the product.
- System and installation shall comply with local laws and regulations.
Precautions
1. C lose the mains water supply valve to separate
the tap.
2. A pply the Teflon tape onto the adaptor and fit it
to the pipe.
Do not turn the water pipe.
3. C onnect the tap to the adaptor.
Install the adaptor with connector
on the cold water pipe.
4. C onnect 1/4 inch orange tubing with the
connector on the adaptor.
Flush water through each filter for
at least 5 minutes before connection.
5. Open the feed valve to supply water to the
filtration system.
• Open the main water supply valve.
The main water must be supplied to operate the water filtration device
normally.
• After installing the product
Get rid of the saved water above the full water in the inner water tank 2
times or more to use.
• When you haven't used for a long time
If you saved the water for a long time or you didn't use, drain the water
inside of the water filtration device completely and remove the newly
filtered water one time to use.
EN
9

Publicidad

Solución de problemas

loading

Este manual también es adecuado para:

Edelwasser pwc-670-gold