Product Overview; Functional Description; Preparing The Dispenser For Use; Instruction And Reporting Obligation - Sulzer COX ElectraFlow Dual Ultra Manual De Instrucciones

4) PRODUCT OVERVIEW

Refer to figure {A}, {B} on page III and figure {F} on
page IV:
1 Trigger
2 Adjustment wheel
3 Release button
4 Front plate
5 Plungers
6 Gear rack
7 Cartridge holder
8 Rack pull
9 Battery pack
10 Battery release button
11 Connection eye
12 Trigger lock
13 Straps
14 Cartridge locator
15 Mixer
16 Battery charge level indicator
17 Battery charge indicator button
18 Cap nut
19 Shoulder-strap (optional)

5) FUNCTIONAL DESCRIPTION

Refer to figure {A} on page III:
• Press the trigger (1) to activate the electric motor on
the driving unit. The plungers (5) move out and
press the material out of the cartridge.
• Dispensed material is evenly transported to the mix-
er (15). Control the dispensed quantity with the ad-
justment wheel (2).
• Release the trigger (1), press the release button (3)
and pull the plungers (5) back by pulling manually
on the rack pull (8) so that the cartridge can be re-
moved.
The cartridges, mixer (15) are not included in
the scope of delivery. Only use cartridges that
are compatible for the dispenser.
EN
6) PREPARING THE DISPENSER
FOR USE

Instruction and reporting obligation

The operator ensures that all activities at the dispenser are
only carried out by authorized persons. He provides thor-
ough instruction for all persons working on the device, with
special emphasis on the residual dangers and safety regu-
lations, based on this instruction handbook.
The operator is obliged to report all defects occurring
during operation to the manufacturer if the instruction
handbook do not contain any information on how to
remedy these. Measures specified by the manufacturer
must be strictly complied with.

Charging the battery

The battery is semi-charged upon delivery. To
ensure the full capacity of the battery, it must
be fully charged before use with the supplied
battery charger.
The Li-ion battery can be charged at any time
without shortening its service life. The battery
is protected against low charge by the "Elec-
tronic Cell Protection" (ECP). When the
battery is empty, the dispenser is switched off
by means of a protective circuit.
Temperature range for battery charging see
"10) Technical data" on page 11.
i CAUTION Risk of injury and damage
to equipment by use of incorrect batter-
ies or battery chargers!
Only use original batteries; the use of incorrect batter-

ies involves the risk of injury and damage to equipment
Never use damaged batteries; toxic fumes or liquids

may be discharged
Only charge the batteries with the original battery

charger Bosch GAL 18V-40 (COX 1020-029/1020-30),
Bosch GAL 1880 CV (COX 1030-31)
If the service life of the battery is considerably

shorter after charging, the battery must be replaced
Instruction handbook ElectraFlow
6 of 12
Dual Ultra · Version 1.3 · 9.4.21