Publicidad
Idiomas disponibles
Idiomas disponibles
en-US
Risk of damage caused by incor-
rect cleaning.
The pre-filter can become damaged
and be less effective as a result.
Do not clean the pre-filter with water.
Do not use pointed or sharp-edged
objects to clean the filter.
Clean the pre-filter with the dusting
brush supplied or with a dry cloth.
After cleaning the fine dust filter and
pre-filter, reinsert the former into the
latter by pressing the round cap on
top of the fine dust filter down as far
as it will go.
To continue achieving the best possi-
ble cleaning results, replace the fine
dust filter (HX FSF-2) with a new one
after approx. 3 years.
Reinsert the pre-filter in the dust con-
tainer (Fig. 36).
To do this, line up the guides (arrows)
and turn the pre-filter back to its orig-
inal position (Fig. 37).
Close the dust container flap, making
sure it clicks into place.
Replace the dust container on the
PowerUnit connector.
Cleaning the dust container
Clean the dust container as required.
Remove the dust container.
Empty the dust container over a
garbage can and lift the pre-filter up-
ward to remove it (Fig. 34).
Clean the dust container using water
and mild detergent.
178
Dry the dust container carefully.
Reinsert the pre-filter in the dust con-
tainer and turn the pre-filter back to
its original position (Figs. 36 + 37).
Replace the dust container on the
PowerUnit connector.
Cleaning the Electrobrush (Fig. 38)
Disconnect the Electrobrush from the
vacuum cleaner (Fig. 10).
Place the Electrobrush upside down
on a level, clean surface.
Use a pair of scissors to cut any
threads or hairs that have wound
themselves around the roller brush.
To guide the scissors, move along the
guide track on the roller brush.
Then run the vacuum cleaner to vac-
uum up the cut threads and hairs.
If the small running wheels are very
heavily soiled or blocked, you can re-
move them for easier cleaning. To re-
move them, use a flat-head screw-
driver.
Removing the roller brush from the
Electrobrush (Fig. 39)
You can take the roller brush out of the
Electrobrush in order to remove stub-
born soiling and clean the inside of the
Electrobrush.
Unlock the flap on the side of the
Electrobrush so that the symbol
becomes visible a.
Lift the flap up as far as it will go b.
Remove the roller brush c.
Publicidad
