Connecting The Product; Switching The Product On And Off; Refilling With Water - EASYHOME PS24D240K1000UD Manual Del Usuario

Operation

Connecting the product

− Connect the product to a properly installed power outlet using the plug-in power
supply.

Switching the product on and off

The amount of humidification can be progressively adjusted with the control knob
1. Turn on the product by turning the control knob
can be used to adjust the intensity of the mist output.
− If the green LED
− If the red LED 2
2. To turn the product off, turn the control knob
„click" sound.
SET THE CORRECT HUMIDITY OUTPUT: Adjust the control knob
rises up to be absorbed by the room air. If mist drops quickly, turn down the
control knob
A NOTE ABOUT HUMIDITY: To reduce excessive humidity or condensation,
especially in small rooms, leave the roomdoor open and adjust mist intensity
to the low output setting.
− Too much humidity in the room may allow moisture to accumulate on surfaces
wherebacteria and fungi can grow. Moisture that gathers may also damage
furniture andwalls, especially wallpaper.

Refilling with water

The integrated safety mechanism automatically stops the humidification
process when there is no water in the water tank
mist is no longer released from the mist outlet slot
1. To use the product again, pull the power supply unit
the water tank
2. Insert the power supply unit into the socket and switch on the product (see
chapter "Switching the product on and off").
14
3 lights up, there is a sufficient amount of water in the water tank
lights up, there is an insufficient amount of water in the water tank
until the mist is rising up.
1
with water (see chapter "Filling with water").
5
1 clockwise. The control knob
counterclockwise until you hear a
1
. The red LED
5
.
13
out of the socket and fill
8
.
1
1
.
5
.
5
so the mist
1
is on and
2