Maintenance - Tineco iFLOOR3 BREEZE Serie Manual De Uso

Blinking blue light:
switching to Max water
flow.
Off: no power or battery
malfunction.
Solid red light: brush roller
has a blockage or not
installed.
During Charging
Breathing blue light:
charging.
Fully Charged
Within 5 minutes of full
charge: solid blue light.
After 5 minutes: light off.

MAINTENANCE

Note:
• For optimal performance and to prevent odors,
always clean and dry DWT, floater, filters, brush
roller, brush roller cover completely after each
use.
• Please make sure each part is installed correctly
or the appliance may not work properly.
• After maintenance, place the appliance on
the storage tray vertically. Do not expose
the appliance to direct sunlight, and store it
indoors in a dry place.
Main Body
1.To reduce the risk of injury, switch off before
performing maintenance.
Fig.D-1
2.Use a cloth to clean the surface with a neutral
detergent. The cloth should be dry to prevent
water from entering the appliance.
Fig.D-2
Dirty Water Tank
1.When dirty water reaches the Max line, the
floater will block off the DWT and create a high
pitched sound indicating it's time to switch off
the appliance.
2.Pull up the tank lid to empty the DWT. Rinse
the inside of the DWT and place back into the
appliance.
Fig.D-3
Filter & Floater
1.If the filter and the floater have been blocked,
rinse with water.
2.Remove the filter from the tank lid, remove the
floater, and rinse both parts with water.
Fig.D-4
Filter
• Grasp recessed area on each side of the
filter and pull upward. Rinse under running
water and must be completely dry before
recombining with the lid of the DWT.
* A spare sponge is provided with your appliance
for convenient replacement.
Fig.D-5
Self-cleaning
1.Place the appliance on the storage tray and
plug in. Press and hold
the self-cleaning process.
2.Once complete, the appliance will begin
charging. Clean the Dirty Water Tank after
cleaning completed.
Fig.D-6
Note:
• Ensure the appliance is plugged in.
• Before self-cleaning cycle, please clean the
DWT and ensure the water level in the CWT
exceeds 40%.
10
for 3s and begin