SOLAC CE4520 Instrucciones De Uso página 11

Downloaded by: pd-oliana on 12-08-2022 14:11 CEST
The lights will now flash sequentially. Press the tempe-
rature level you require:
1-Coffee - Low temperature
2-Coffees - Medium temperature
Steam - High temperature
Once the button is pressed, the 1-coffee button light will
flash quickly to confirm that the temperature has been
selected. The coffee maker will beep twice.
Programming water hardness
Access the programming menu.
Press the 2-coffee button to enter the water hardness
setting. The lights will show which level it is at:
1-coffee 2-coffees
X
X X
X X
Once the level is shown, the lights will flash sequen-
tially.
Select the water hardness for your area based on the
following table:
Measurement Low
hardness
German <10º
degrees
French <18º
degrees
mg CaCO3/L <180
Once selected, the coffee maker switches back to Stan-
dby mode.
FACTORY SETTINGS RESET
Place a container under the steam pipe.
Access the programming menu.
Open the steam control fully.
Press the 1-coffee button. The buttons will all flash at
the same time, indicating that all values have been re-
set to the factory default settings.
The 1-coffee and 2-coffee buttons will flash to tell you to
close the steam control.
ONCE YOU HAVE FINISHED USING
THE APPLIANCE:
Turn the appliance off, using the on/off switch.
Unplug the appliance from the mains.
Clean the appliance
Steam Level
Low water
hardness
Average
water
hardness
X High water
hardness
Average High
hardness hardness
10º - 20º >20º
18º - 36º >36º
180 - >360
360
SAFETY THERMAL PROTECTOR
The appliance has a safety device, which protects the
appliance from overheating.
When the appliance switches itself on and off repeated-
ly, for reasons other than the thermostat control, check
to ensure that there are no obstacles that impede co-
rrect air entry or expulsion.
If the appliance turns itself off and does not switch it-
self on again, unplug it from the mains supply and wait
approximately 15 minutes before reconnecting it. If it
fails to switch on again, take it to one of the authorised
technical assistance services.
AUTO-OFF FUNCTION
SOLAC machines are designed to save energy.
Consequently, the appliance switches off automatically
30 minutes after the last operation.
To return to normal operation, simply press any button.
CLEANING
BETWEEN COFFEES
To enjoy the best coffee, we recommend always kee-
ping the coffee maker clean.
Empty the coffee out of the filter by giving it a sharp tap
or with the help of a spoon or utensil.
Clean the filter with warm water or with a fine
cleaning brush to remove any coffee remains.
Use a damp cloth to wipe the shower (the filter
holder support) to remove any coffee remains.
CAUTION: Make sure not to touch any of the
parts involved in the brewing (Filter, Shower) im-
mediately after making a coffee.
BASIC CLEANING
Unplug the appliance from the mains and let it cool be-
fore performing any cleaning task.
Clean the equipment using a damp cloth with a few
drops of washing-up liquid and then dry.
Do not use solvents or products with an acid or base
pH, such as bleach or abrasive products, to clean the
appliance.
Do not let water or any other liquid get in through the
air vents to avoid damaging the appliance's internal
components.
The following parts are dishwasher safe:
- Water tank
- Drip tray
- Coffee filters
Next, dry all the parts before refitting them and storing
the appliance.
EN