Make A Call - JVC KD-X382BT Manual De Instrucciones

Bluetooth®
Improve the voice quality
While talking on the phone...
1
Press and hold .
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3
Repeat step 2 until the desired item is selected or activated.
4
Press to exit.
To return to the previous setting item, press
[MIC GAIN] [LEVEL –10] to [LEVEL +10] ([LEVEL –04]): The sensitivity of the
microphone increases as the number increases.
[NR LEVEL] [LEVEL –05] to [LEVEL +05] ([LEVEL 00]): Adjust the noise reduction level
until the least noise is being heard during a phone conversation.
[ECHO CANCEL] [LEVEL –05] to [LEVEL +05] ([LEVEL 00]): Adjust the echo cancellation
delay time until the least echo is being heard during a phone conversation.
• Call quality may depend on mobile phone.
Make the settings for receiving a call
1
Press to enter Bluetooth mode.
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3
Repeat step 2 until the desired item is selected or activated.
To return to the previous setting item, press
14
ENGLISH
[SETTINGS]
[AUTO ANSWER] [01 SEC] to [30 SEC]: Answers an incoming call automatically in the selected
[RING ILLUMI]
.

Make a call

Default: [XX]
You can make a call from the call history, phonebook, or dialing the number.
Call by voice is also possible if your mobile phone has the feature.
1
2
3
To return to the previous setting item, press
.
time (in seconds). ; [OFF]: Cancels.
[BLINK 01] to [BLINK 05] ([BLINK 02]): Selects the blinking pattern for the
buttons as notification when there is an incoming call. ; [OFF]: Cancels.
Press to enter Bluetooth mode.
"(First device name)" appears.
• If two Bluetooth phones are connected, press
to the other phone.
"(Second device name)" appears.
Turn the volume knob to select an item (page 15), then press the
knob.
Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
Default: [XX]
again to switch
.