Descargar Imprimir esta página

Modine CDD Serie Manual Tecnico página 29

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 74
• EU-OEL: 9000 mg/m
A concentration above 100000 ppm may cause pulmonary oedema and be fatal.
Continuous monitoring of CO
1.24 If you have any doubts or queries, please contact Modine or the dealer.
2. Applications
2.1
The unit must not be put into service until the machine to which it will be incorporated has been declared in conformity
with the Machinery Directive 2006/42/CE, see "Declaration of Incorporation" page 143. The unit is defined as "Partly
completed machinery".
2.2
The product must only be used for the stated purpose: use other than that prescribed is to be considered improper and
exempts Modine from all liability.
2.3
Use in unspecified operating conditions must be considered incorrect or improper.
2.4
Make sure that the fluids used are compatible with the materials used to build up the model. Bear in mind that the
CO
available on the market may contain small quantities of water: check that the concentration of water in the CO
2
compatible with all the components of the system.
2.5
The minimum protection level of the model is IP42. Refer to the annexe "ADDITIONAL INFORMATION SHEET" (when
present).
2.6
All the models are supplied with heat exchangers manufactured to internal standards in accordance with DIN8964 for
internal cleaning.
2.7
Please refer to any attachments to this manual.
2.8
Product description (see identification code, Chapter 15.2):
2.8.1
CDD Aeroevaporators (Unit Coolers) with CO
between air and another fluid, CO
of 2 finned packs interconnected to a tube coil. The flow of relatively warm ambient air, created by the axial fans,
passes through the exchanger where the evaporation of the liquid flowing through the tubes takes place, resulting
in the absorption of the heat and the lowering of the outlet air temperature.
, 5000 ppm as TWA.
3
concentration is recommended when installing models in confined spaces.
2
refrigerant series CDD have the task of optimising the heat exchange
2
, in a refrigeration system. Inside a casing there is a heat exchanger consisting
2
is
2
29
www.modine.com

Publicidad

loading