SNOWJOE iON100V-21SB-CT Manual Del Operador página 12

Fig. 8
Handle frame
2. Rotate the handle frame up in a comfortable operation
position (Fig. 9).
Fig. 9
3. Lock the handle frame in position by rotating the handle
frame locks on both sides counter-clockwise (Fig. 10).
Fig. 10
Handle frame
Discharge Chute Assembly
1. Place the discharge chute assembly onto the gear plate,
aligning the 3 holes in the gear plate, and push down until
the chute is flush and flat against the housing (Fig. 11).
Fig. 11
Handle frame
lock
Gear
plate
2. Use the 3 discharge chute screws to secure the discharge
Fig. 12
Handle frame
Gear plate
Operations
m
entire safety section before proceeding.
NOTE: Before inserting the battery pack(s), verify that the snow
blower's auger and rubber plates are firmly secured. Perform a
test run to ensure that the rotor turns freely.
Starting + Stopping
m
Rotate to
the snow blower is switched on. Keep hands and feet away
lock
from the auger.
1. Open the battery compartment cover and then push the
12
chute assembly to the gear plate as shown. Tighten with
the provided hex key (Fig. 12).
Discharge chute
assembly
Screws
WARNING!
AVOID INJURY. Read and understand the
WARNING!
The auger starts rotating immediately after
battery pack(s) down until it clicks and locks into position
(Fig. 13). Either side of the battery compartments may be
used. Close the cover.
Discharge
chute assembly