SNOWJOE iON100V-21SB-CT Manual Del Operador página 17

2. Use 2 10 mm wrenches to remove the bolts and nuts that
are used to fix the right side panel. Then remove the right
side panel to expose the belt, as shown (Fig. 26).
Fig. 26
Old belt
Nuts
NOTE: The 2 bolts located on the left have 2 nuts on the back,
while the other 4 bolts don't. Use one 10 mm wrench to hold
the left two bolts steady and remove the nuts with the other 10
mm wrench first, and then remove all the bolts.
3. Use the needle nose pliers to remove the spring from the
hook to release the belt tension (Fig. 27).
Fig. 27
Spring
4. Remove the drive belt by slowly turning the auger pulley
counterclockwise while pulling the belt outwards (Fig. 28).
Fig. 28
Right side
panel
Bolts
5. Install the new drive belt, rotating it onto the pulleys
(Fig. 29).
Fig. 29
NOTE: Rotate the new drive belt first around the engine pulley,
then the idle pulley, and finally around the auger pulley. Slowly
turn the auger pulley clockwise to drive the belt inwards
Needle nose
(Fig. 30).
pliers
Fig. 30
6. Use needle nose pliers to reinstall the spring onto the
hook to tension the belt. Replace the side panel on the
unit, secure with the original hardware. The snow blower is
ready to use.
17
Spring
Auger pulley
Drive belt
Auger pulley
New drive
belt
Spring hook
Engine
pulley
Idle pulley
Belt