Publicidad
Idiomas disponibles
Idiomas disponibles
Hanging the Fan
REMEMBER to turn off the power. Follow the
steps below to hang your fan properly:
Step 1. Pass the 120-volt supply wires through
the center hole in the ceiling hanger bracket as
shown in Fig. 5.
Step 2. Secure the hanger bracket to the ceiling
outlet box with the screws and washers provided
with your outlet box.
Step 3. Remove the hanger pin, lock pin and set
screws from the top of the motor assembly. (Fig. 6)
Step 4. Route wires exiting from the top of the fan
motor through the coupling cover, decorative
cover, canopy and then through the downrod.
(Fig. 7)
WARNING
FAILURE TO PROPERLY INSTALL
LOCK PIN AS NOTED IN STEP 5
COULD RESULT IN FAN LOOSENING AND
POSSIBLY FALLING.
Step 5. Align the holes at the bottom of the
downrod with the holes in the collar on top of the
motor housing (Fig. 7). Carefully insert the hanger
pin through the holes in the collar and downrod. Be
careful not to jam the pin against the wiring
inside the downrod. Insert the lock pin through the
hole near the end of the hanger pin until it snaps
into its locked position, and tighten set screws as
shown in Fig.7. Cut off excess fixture wires
leaving approximately 6 to 9 inches above top of
hanger ball/downrod assembly.
Ceiling hanger
bracket
Figure 5
120V wires
Hanger ball
Lock
pin
Figure 6
Lock pin
Downrod
UL Listed
electrical box
Canopy
Washers
Mounting screws
(supplied with
electrical box)
Decorative cover
Coupling cover
Lock pin
Hanger pin
Figure 7
Hanger pin
Set screw
6" to 9"
Downrod/ball
assembly
Hanger pin
Motor
assembly
4.
Publicidad
