Publicidad
Idiomas disponibles
Idiomas disponibles
Finishing the Installation
Step 1. Tuck connections neatly into ceiling
outlet box.
Step 2. Slide the canopy up to mounting bracket
and place the key hole on the canopy over the
screw on the mounting bracket, turn canopy until
it locks in place at the narrow section of the key
holes. (Fig. 11)
Step 3. Align the circular hole on canopy with the
remaining hole on the mounting bracket, secure
by tightening the two set screws. Note: Adjust the
canopy screws as necessary until the canopy and
canopy cover are snug.
WARNING
Make sure the notch on the hanging bracket properly
sits in the groove in the hanger ball before attaching
the canopy to the bracket by turning the housing until
it drops into place.
Canopy
Decorative
cover
Figure 11
Blade
Step 4. Attach blade to the motor assembly using
three (3) blade screws as shown in Figure 12.
Repeat this step for the remaining blades.Tighten
the screws securely.
Step 5. Remove one of the mounting screws on
mounting plate of motor assembly, then loosen
the other two.（Fig.13）
Motor
assembly
Blade screw
Figure 12
Step 6. Insert the wires with 2 single pin
connectors from the motor assembly through the
center hole in the switch housing. Attach the
switch housing to the mounting plate on the motor
assembly by placing the keyhole slots from the
switch housing onto the two protruding mounting
screws heads. Adjust the switch housing until the
screw heads are aligned with the keyholes, then
re-install the mounting screw previously removed
Mounting screw
on step 5. Tighten all mounting screws securely.
Figure 13
Switch
housing
Mounting screw
Figure 14
6.
Publicidad
