Koro BEREITER_003 Manual De Instrucciones página 16

5. TRO UBLESHOOTING
PROB L EM
The milk frother does not work.
The inserted whisk (4,5) does not
turn.
Milk is not being frothed.
30
SOLUTION
Make sure that the power chord (12) is correctly
connected to the socket.
The milk frother is not switched on. Press the on/
off switch (9) to switch on the milk frother.
The milk frother is overheated and the overheat
protection is preventing it from switching on.
If this is the case, the operating mode symbols
(8, 10, 13, 14) light up continuously. Wait until
the milk frother has cooled down. Fill the milk
frother with milk at least up to the MIN mark to
avoid this error. Now remove the jug (7) briefly
from the base (11).
The whisk drive shaft is possibly stuck
milk residues. Pull out the power chord (12) and
fill some lukewarm water into the jug (7).
jug (7). Let the water soak in for a while and
then try to turn the whisk drive axle several
times by hand. Then pour out the water.
The milk frother should now work again.
Check whether the whisk (4 or 5) is inserted cor-
rectly. Push the whisk onto the whisk drive shaft
as far as it will go.
The foam quality depends on the milk used and
can vary greatly.
Use cow's milk with a fat content of 3.5% to
obtain a firm foam.
Alternative types of milk may behave differently
when foaming. The frothability depends on the
protein and fat content. The higher both con-
tents, the better the milk foam.
Use a different milk to obtain a better milk
foam.
6. WARR AN T Y
6.1 WARRANTY
Our products are subject to the legal warranty of 2 years. Claims beyond this period
can only be processed in conjunction with the proof of purchase. Active parts exclude
a warranty claim in the case of normal wear and tear. The service life depends on the
respective treatment and use of the products and is therefore variable.
Two years warranty is guaranteed by the manufacturer. If you have any questions about
the operation or function of our products, please contact our customer service:
service@koro-shop.co.uk
6.2 DECLARATION OF CONFORMITY
The manufacturer of this product is
KoRo Handels GmbH
Hauptstraße 26
10827 Berlin, Germany
This product complies with the following European Directives:
2014/35/EU (LVD)
2014/30/EU (EMC)
2011/65/EU (RoHS)
2009/125/EC (ErP)
7. DISP OSAL
DISPOSING OF THE PRODUCT (WEEE)
Waste electrical equipment must not be disposed of with household
waste!
The European Directive 2012/19/EU applies to this product and it must
not be disposed of with normal household waste. Inform yourself about
the local regulations for separate collection of electrical and electronic
equipment. Follow the local regulations and do not dispose of old de-
vices with household waste. Disposing of old equipment in accordance with the regu-
lations will protect the environment and the health of others from possible negative
consequences. Material recycling helps to reduce the consumption of raw materials.
31