JULIUS MAYER JM35-F Manual De Instrucciones página 21

GENERAL SAFETY INSTRUCTIONS
For the electrical connection, a
power connection with 230 V/50 Hz
and an on-site disconnecting device
(fuse) must always be available at
the installation site.
To avoid hazards, the power cord
may only be replaced by the
manufacturer, its customer service
or a similarly qualified person.
Only the same type of cable supplied
by the motor manufacturer may be
used.
Attach permanently mounted
control devices in a visible position.
Both rated torque and rated
operating time must be compatible
with the characteristics of the driven
equipment.
ATTENTION!
Observe the notes on installation
and operation of the system!
There is an increased risk of injury if
this is not observed!
Proper operation of the equipment
is only guaranteed if it is properly
installed, assembled, supplied with
sufficient power and maintained.
Secure the system against
unauthorized operation.
Take safety precautions against
unintentional switch-on.
Before working on the system,
disconnect all connecting lines to be
installed from the power supply and
secure them against unintentional
reconnection. Remove all lines that
are not required.
Set all devices that are not required
for operation with the motor out of
operation.
Attach the operating element of a
manual release (emergency hand
crank) below a height of 1.8 m.
ATTENTION!
It is essential to observe the
instructions for correct use and the
operating conditions!
There is an increased risk of injury if
used improperly!
Use the motors only for opening and
closing awnings or textile sunshades.
Only use original components and
accessories from the manufacturer.
Instruct all persons in the safe use of
the engine.
Watch the moving equipment and
keep people away from it until the
movement has stopped.
Place warning signs on automatically
moving equipment if necessary.
Prohibit children from playing with
stationary controls or with the remote
control.
Store the handheld transmitter in such
a way that unintentional operation,
e.g. by children playing, is impossible.
Carry out all cleaning work on the
on the driven system in a de-energized
state.
For moving and open / extended
systems be particularly careful, as
parts can may fall down if fastenings
(e.g. springs, brackets, consoles, etc.)
are loose or broken.
21