Publicidad
Idiomas disponibles
Idiomas disponibles
Carefully align top and middle pole assembly (4 & 5) onto bottom pole
3.
section (6) as shown. Bounce sections together using a wood scrap, while
maintaining alignment, until the middle pole section (5) reaches the mark
line on bottom pole section (6).
You should have a 4.0" (10.2 cm) overlap when properly assembled.
NOTE: IF MINIMUM POLE ENGAGEMENT WHICH ALLOWS THE HARDWARE TO BE ASSEMBLED
CANNOT BE ACHIEVED !! STOP !! DO NOT PROCEED TO THE NEXT STEP! - CALL SPALDING
CUSTOMER SERVICE FOR ASSISTANCE.
TWO CAPABLE ADULTS REQUIRED FOR THIS PROCEDURE.
FAILURE TO FOLLOW THIS WARNING COULD RESULT IN
SERIOUS INJURY AND/OR PROPERTY DAMAGE.
WHEN PROPERLY POUNDED
TOGETHER, THE POLE SECTIONS
SHOULD HAVE A 4.0" (10.2 CM)
OVERLAP.
IMPORTANT!
Align the middle pole section (5) into the
bottom pole section (6) as shown.
5
MIDDLE POLE
MARKED LINE
6
BOTTOM POLE
WARNING!
CAUTION!
MARK LINE
(FRONT OF POLE)
TOP POLE
MIDDLE POLE
(FRONT OF POLE)
4.0"
BOTTOM POLE
(10.2 cm)
(FRONT OF POLE)
Wood Scrap
(not supplied)
12
4
5
6
Publicidad
