Publicidad
Idiomas disponibles
Idiomas disponibles
Fanaway Fraser Installation Instructions
WOBBLE:
NOTE: ceiling fans tend to move during operation due to the fact that they are mounted on a rubber
grommet. If the fan was mounted rigidly to the ceiling it would cause excessive vibration. Movement of a few
centimetres is quite acceptable and DOES NOT suggest any problem.
TO REDUCE THE FAN WOBBLE:
Please check that all screws which fix the mounting bracket and down rod are secure.
NOTE: This fan has been precision balanced at the factory and will not need to be balanced again.
NOISE:
When it is quiet (especially at night) you may hear occasional small noises. Slight power fluctuations and
frequency signals superimposed in the electricity for off-peak hot water control, may cause a change in fan
motor noise. This is normal. Please allow a 24-hour "settling-in" period, most noises associated with a new
fan disappear during this time.
Please note that this is not a product fault and as such is not covered under warranty – All electric motors
are audible to some extent.
NOTE: Always turn OFF the power at the mains switch before performing any maintenance or
attempting to clean your fan.
•
Every 6 months periodic cleaning of your ceiling fan is the only maintenance required. Use a soft brush
or lint free cloth to avoid scratching the paint finish. Please turn off electricity power when you do so.
•
Do not soak or immerse your ceiling fan in the water or other liquids. It could damage the motor or the
blades and create the possibility of an electrical shock.
•
Ensure that the fan does not come in contact with any organic solvents or cleaners.
•
To clean the fan blade, wipe with only a damp clean cloth with NO organic solvents or cleaners.
•
The motor has a permanently lubricated ball bearing so there is no need to oil.
-
WARNING – Keep new and used batteries away from children.
-
CAUTION – Do not ingest battery—Chemical burn hazard.
-
Always use 2 x AAA battery type with this ceiling fan remote controller.
-
Ensure the batteries are inserted with the correct polarity.
-
To prevent false operation during battery insertion or replacement, this ceiling fan must be disconnected
from the supply mains.
-
Remove batteries from the product when not in use for long periods of time.
-
Batteries must be removed from the remote transmitter before it is discarded.
12 | P a g e
AFTER INSTALLATION
CARE & CLEANING
SAFETY PRECAUTIONS FOR BATTERY
Publicidad
