Publicidad
Idiomas disponibles
Idiomas disponibles
0° Bevel Stop
Checking 0° Bevel Stop Setting
1. Hold the saw head assembly (Fig. 17, 24)
down and push in the head assembly lock
pin (35) to keep the saw in the DOWN posi-
tion.
Fig. 17
24
19
2. Slide the saw head assembly (24) complete-
ly to the back and engage the slide rail lock
knob (33) by tightening the knob to the right
(clockwise).
3. Rotate the table to the 0° miter position.
4. Rotate the bevel lock knob (30) clockwise to
unlock the head assembly.
5. Tilt the saw head assembly (24) to the left
(counterclockwise), then rotate to the right
(clockwise) until you feel the stop in the ver-
tical position. This is where the saw is cur-
rently set for 0° bevel cut.
6. Use a combination square (Fig. 18) to check
that the blade is 90° (square) to the table
(Fig. 17, 19). Place the square's ruler edge
against the table and slide it to contact the
blade (Fig. 18, 21) with the vertical side of
the square's head.
7. Check that the saw blade's plate (21),
not the saw blade's teeth, is touching the
square's 90° side. If the saw blade's plate
is not in full contact with the square's body
90° side, see "Adjusting 0° Bevel Stop (Blade
90° to Table)."
16099221PK GCM18V-07S OSI 20220506.indd 24
Adjustments
Fig. 18
11
35
33
Combination
square
30
Adjusting 0° Bevel Stop (Blade 90° to
Table)
NOTE: Use a 12 mm wrench for the adjustment.
1. Lower head assembly (Fig. 17, 24) and en-
gage head assembly lock pin (35).
2. Slide the head assembly (24) completely
to the back and engage the slide rail lock
knob (33) by tightening the knob to the right
(clockwise).
3. Rotate the bevel lock knob (30) clockwise to
unlock the head assembly.
4. Rotate the 0° bevel adjustment screw (Fig.
19) clockwise to adjust the head to the right.
Rotate the 0° bevel adjustment screw (Fig.
19) counter-clockwise to adjust the head to
the left.
5. Follow the procedure in "Checking 0° Bevel
Stop Setting" to check your modifications.
If further adjustment is required, repeat the
steps above.
-24-
21
Square's
90° side
19
5/6/22 11:27 AM
Publicidad
