Hilti NURON SF 4-22 Manual De Instrucciones página 34

Gear selector switch
=
Forward/reverse switch with
%
transport lock
Grip
&
Installation opening for acces-
(
sories
3.2 Intended use
The product described is a hand-held cordless drill / driver or hammer drill
/ driver, depending on the version. It is designed for driving and removing
screws, for drilling in metal, wood and plastic. The hammer drill / driver
version is also designed for drilling in cellular concrete and masonry.
For this product, use only Hilti Nuron lithium-ion batteries of the B 22
•
series. For optimum performance, Hilti recommends the batteries stated
in the table at the end of these operating instructions for this product.
• For these batteries, use only Hilti chargers of the type series stated in
the table at the end of these operating instructions.
3.3 Items supplied
Hammer drill/driver / drill/driver, operating instructions.
Other system products approved for use with this product can be found at
your local Hilti Store or at: www.hilti.group
3.4 Status indicators of the Li­ion battery
Hilti Nuron Li-ion batteries can indicate state of charge, fault messages and
the battery's state of health.
3.4.1 Indicators for state of charge and fault messages
WARNING
Risk of injury by a falling battery!
▶ If the release button is pressed with a battery inserted in the product,
subsequently check that the battery is correctly re-engaged and secure.
Short-press the release button of the battery to get whichever of the following
status indications is applicable at the time.
State of charge and, if applicable, faults are indicated constantly as long as
the connected product is switched on.
Status
Four (4) LEDs show constantly
green
Three (3) LEDs show constantly
green
30 English
Battery
)
Work-area light (LED)
+
Control switch with electronic
§
speed control
Battery release button
/
Battery status indicator
:
Meaning
State of charge: 100 % to 71 %
State of charge: 70 % to 51 %
2272252
*2272252*