Publicidad
Idiomas disponibles
Idiomas disponibles
USE
Important Note
Keep all threads are clean and oil it before use!
Do not use an impact wrench, this will damage the spindle.
Drill through the bearing cage with a suitable drill bit.
Destroy the cage, so that one or two bearing balls can be moved till
there is enough space for a puller ball. Same procedure applies to the
opposite side.
Choose an appropriate pair of puller balls (6, 7 or 8).
Insert the puller balls into the bearing and turn it 90°.
The ball can no longer be pulled out from bearing.
Install the puller legs (2), the spindle (1) and if required the
leg extension (3) to the bridge (4).
Install the appropriate pair of puller balls (6, 7 or 8) to the
puller legs.
When all parts of the puller are assembled, turn the spindle
clockwise and lightly pre-tension the tool.
Check if all puller components are correct mounted and pull-
off the bearing (A) from the stub shaft (B) by turning the
spindle clockwise.
Warning: Always wear work gloves and safety glasses
when working with this tool.
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste. Packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with
the environment. Contact your local solid waste authority for recycling information.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
