Descargar Imprimir esta página

Alice's Garden BOUNE SS200BLG Manual De Instrucciones página 11

Ocultar thumbs Ver también para BOUNE SS200BLG:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 8
Check all bolt covers or sharp edges and replace if necessary.
Check swing seats, chains, ropes and other fasteners for signs of damage.
Replace defective items as instructed.
MAINTENANCE
The metal parts do not need any particular care. However, in certain regions (ie seaside areas), cer-
tain coatings could be prone to damage. In this case, it is advised to use a rust prevention treatment.
All parts that are under constant friction can be oiled regularly whith a suitable lubricant.
The ground on which the play centre is placed should be controlled regularly. All elements such as
stones or other objects that could cause injury in the case of a fall, should be removed.
It is advised to remove the structure during the winter period, when not in use, to avoid any deterio-
ration due to bad weather conditions.
Check seats and other means of attachments for evidence of deterioration.
PRACTICAL ADVICE
Certain safety checks should be carried out regularly on the product. Remove any sharp edges, replace
missing screw covers, tighten the nuts and bolts etc, to avoid any danger through normal wear and tear or
any upturning of the product.
FIXING INTO THE GROUND (SEE P.23)
1. Place the product in the desired position, mark a square 300×300mm around each foot (the foot
must be in the center of the square) and dig a hole 300mm/12in deep.
2. Fill those holes with a minimum of 300mm/12in of concrete. Do not exceed the ground level. Fit the
embedding piece into the center of the concrete so that fixtures for screwing the posts into place
rise out of the concrete.
3. When the concrete is dry, screw the posts to the embedding pieces.
4. Cover up the sealings with earth.
IMPORTANT ! For safety reasons, the product must be embedded
into the ground. Wait until the concrete is set before using the play center and check the an-
chorage regularly. As instructed in the assembly notice,
the fastenings to the ground must be placed at ground level or below
25/11/2022
the ground level in order to avoid risks of tipping over.
IT MUST BE USED UNDER ADULT SUPERVISION.
EN
11

Publicidad

loading