zopa MATRIX ZOP022580 Manual página 19

SEAT ADJUSTMENTS
10. To adjust the height of the MATRIX, squeeze the headrest adjustment handle (K)
on the back of the headrest (A) and move the headrest up or down to one of its
positions until the correct height is achieved.
11. The correct height of the headrest is when there is 1 cm between the child's shoulder
and the lower edge of the headrest (A). Once the right fit is found release the handle
and check the headrest to ensure it is locked into position.
12. The recline of the MATRIX backrest can be adjusted to enable different sitting
positions. Pull the Recline adjustment handle (G) and pull the seat forward or
backward relative to the base.
IMPORTANT: NEVER place your child in the MATRIX whilst it is not fitted in a car.
The MATRIX should never be used free-standing as it may tip backwards
IMPORTANT: The lap belt is worn low over the hips. Check that the lap belt passes
through both red lap belt side guides (F) and the lap belt middle guide (E). Check
that the shoulder belt passes through the red shoulder belt guide (L) then diagonally
across the child's chest and through the red lap belt side guide (F) nearest to the seat
belt buckle. Finally, check that all slack has been removed from the vehicle seat belt.
IMPORTANT: Make sure the seat belt buckle is not wedged or interfering with the lap
belt side guides (F).
WARNING: An unoccupied MATRIX should be secured using a 3-point seat belt or the
ISOFIX connectors if available.
IMPORTANT: DO NOT recline the child seat's backrest beyond the allowable adjustable
range. If you hear a loud "click" whilst adjusting the backrest, then you have gone past
the allowable range. Reclining the vehicle seat may adversely affect the position of the
vehicle seat belt across the child and may result in death or serious injury during a crash.
Refer to your vehicle owner's manual for adjusting the vehicle seat back with child seats.
19