Publicidad
Idiomas disponibles
Idiomas disponibles
FIG. 1
6.2
Replacing the bearings
Disassembly
The drive wheel bearings (6001 2RS) are mounted by applying pressure. To remove them, you simply
●
need to push them from the inside, using a pin dri and a hammer.
Assembly
Posi on a new bearing on the inner side of the hub, taking care to insert it evenly (it must be co-axial
●
with the hub, otherwise it won't go in).
Before posi oning the bearing, on the opposite side, you need to insert the quick removal axle into
●
the bearing which has already been inserted, so that the axle itself acts as a guide for the two
bearings. This way, you make sure that the hub and two bearings are co-axial.
6.3
Brake inspec on
To check the proper func oning of the brakes, first examine the integrity of each brake component (lever,
lining, clamp), then press the brake levers one at a me to check whether each independently ac vates the
brake clamp.
OPEN AND CLOSED BRAKE CLAMP
6.4
Derailleur inspec on
Raise the front wheel with a tripod so that it can turn freely. Move the levers in the direc on of travel, ac vate
the derailleur by means of the two levers on the right-hand crank and check whether each gear change
FIG. 2
FIG. 3
11
FIG. 4
BRAKE LEVER
FIG. 5
Publicidad
