RedMax CV54 Manual De Usuario página 24

4. Put the dipstick in the hole for the dipstick and
tighten it.
5. Loosen and pull the dipstick out and read the oil
level.
6. Make sure that the oil level in the hydraulic oil
tank is between the 2 horizontal lines on the
dipstick.
7. Fill with hydraulic oil if the hydraulic oil level is
below the lower line, but do not fill above the
Technical data on page 29 for
top line. Refer to
recommended oil.
8. Install the hydraulic cover and the 2 knobs.
Note:
To replace the hydraulic oil, speak to an
approved service agent.
Lubrication, general information
• Remove the ignition key to prevent accidental
movements during lubrication.
D
Refer Lubrication
to
Lubricate the grease nipple on the pivot axle with a
A
grease gun.
Lubricate the grease nipple on the wheel axle with a
B
grease gun.
24
B
D
• Clean the area before you lubricate a part on the
product.
• Use engine oil when you lubricate with an oil can.
• When you lubricate with grease, use a chassis
or ball bearing grease that prevents corrosion.
Remove unwanted grease after lubrication.
• Lubricate 2 times a week if you operate the
product daily.
• Do not spill lubricant on the drive belts or the
grooves of the belt pulleys. If you do spill, clean
with alcohol. If the friction between the drive belt
and the pulley is not sufficient after you clean
with alcohol, replace the drive belt.
CAUTION:
other petroleum products to clean drive
belts.
Lubrication schedule
A
Interval
Month
Yearly
ly
Do not use gasoline or
B
D
F
Each Each Each
50 250 500
hours hours hours
X X X
X X X
1997 - 003 - 07.12.2022