Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
The engine becomes too hot.
The battery does not charge.
The product moves slowly, with irregular
speed or not at all.
The drive of the blades do not engage.
The transaxle leaks oil.
The cutting result is unsatisfactory.
1997 - 003 - 07.12.2022
Cause
The air filter is clogged.
There is overload in the engine.
The airflow around the engine is not sufficient.
The engine speed regulator is damaged.
The oil level is too low.
There is dirt in the fuel line.
The spark plug is defective.
The connection at the cable connectors on the battery terminals
To clean the battery on page 18 .
is bad. Refer to
The charging cable is disconnected.
The charging system is defective.
The parking brake is engaged.
The hydraulic release lever is engaged.
The drive belt on the transmission is loose or damaged.
There is air in the hydraulic system.
The drive belt on the mower deck is loose.
The electromagnetic coupling contact is loose.
A fuse is blown.
The seals, housing or gaskets are damaged.
There is air in the hydraulic system.
The tire pressure is different on the right and left sides. Refer to
Tire pressure on page 19 .
The blades are damaged.
The cutting deck is damaged and not parallel to the ground.
The blades are blunt. Refer to
21 .
The product is operated at too high forward or rearward speed.
To get a good cutting result on page 15 .
Refer to
The grass is long or wet. Refer to
page 15 .
There is grass blockage in the cutting deck. Refer to
the product on page 18 .
To examine the blades on page
To get a good cutting result on
To clean
27
Publicidad
