NORAUTO NO0503 Manual De Usuario página 54

AC:
EN
1. When using a 220-240 V AC mains electric supply it is advisable to use a residual
current device (RCD).
2. To connect your compressor cooler to 220–240V AC supply:
3. Plug in the 220-240 V AC power lead into the AC power socket on the back panel
of the compressor cooler.
4. Connect the free end of the power lead to a 220–240 V AC supply.
TURNING ON OR OFF
• To turn on, press the ON/OFF button once.
When the compressor cooler is on, the power LED will light up. The display will show
the current cabinet temperature.
• To turn off, press and hold the ON/OFF button for 5 seconds.
When the compressor cooler is off, the power LED and the display will go blank.
NOTE: The temperature displayed on the display is the temperature inside the
refrigerator compartment. The temperature may be different elsewhere in the
refrigerator.
BATTERY MONITOR ADJUSTMENT WITH ANTI-LOW VOLTAGE PROTECTION
SYSTEM
• The device is fitted with a 3-level battery preservation monitor with anti-low voltage
protection system.
• It has three settings: "H1", "H2" and "H3", to monitor the vehicle's battery to prevent a
full discharge. The higher the setting the higher the cut-off voltage will be.
• When the compressor cooler is switched on and connected to the vehicle's power
supply while the vehicle ignition is switched off, the compressor cooler will turn off
automatically when the supply voltage drops below the set level. The cooler will turn
on again once the battery has been charged to the voltage level required for restart.
• ATTENTION! Risk of damage! If the device is shut down by the battery monitor
function, the battery will no longer be fully charged. Avoid restarting the device
or using it without first carrying out long charging phases. Ensure the battery is
charged.
• The battery monitor responds faster to the "H3" level than to the "H1" and "H2" levels.
BATTERY
PROTECTION
LEVEL
H1
H2
H3
IMPORTANT: If the compressor cooler cuts out prematurely, this may be due to the
battery protection level being set too high. Consider lowering the battery protection
level.
• When the compressor cooler is connected to the starting battery of your vehicle, then
it is recommended to have the battery monitor set to "H3".
• When the compressor cooler is connected to an auxiliary/secondary battery, then it
is recommended to have the battery monitor set to "H1".
1. Connect and switch on the compressor cooler.
2. Press the "UP" and "DOWN" buttons at the same time for about five seconds. "H1",
"H2" or "H3" will flash on the display.
3. Then, press the "UP" or "DOWN" button to select the battery monitor level "H1", "H2"
54
12 V SWITCH- 12 V RESTART
OFF VOLTAGE VOLTAGE
10.3V
10.8V
11.3V
24 V SWITCH-
OFF VOLTAGE
11.1V 21.5V
11.8V 22.3V
12.6V 24.3V
24 V RESTART
VOLTAGE
22.7V
23.7V
25.7V