NORAUTO NO0503 Manual De Usuario página 55

or "H3", to protect your vehicle battery. "H2" is set as default.
4. The selected monitor level "H1", "H2" or "H3" will flash on the screen for a few
seconds after being set and the screen will flash a few times before showing the
current temperature again.
SETTING THE COMPRESSOR COOLER OPERATING MODE
1. To set the operating mode, tap the "SET" button twice in succession.
2. The letters "HH" or "ECO" will flash on the screen.
3. Then, use the "UP" or "DOWN" buttons to select the desired mode. The letters "HH"
or "ECO" of the operating mode will flash on the display for a few seconds.
4. Finally, the system displays the current temperature on the screen again.
• High speed (HH) mode: the temperature decreases much faster than in the ECO
mode. The high-speed indicator will illuminate a red light and display "HH" when the
compressor cooler is running on high speed mode
• ECO mode: the compressor cooler operated in energy-saving mode. ECO mode
can reduce noise from 40dB to 35dB and save energy. On the other hand, the
temperature decreases more slowly than in the "HH" mode.
TIP: It is recommended to use the ECO mode to conserve energy.
TEMPERATURE SETTING
In the refrigerator compartment, the temperature can be adjusted from 0°C to 10°C ,
and in the freezer compartment, the temperature can be adjusted from 0°C to -20°C.
WARNING, for a good conservation of frozen food it is strongly recommended to set
the cooler between -10 °C and -20 °C.
• Press the "SET" button once only to start setting freezer temperature, and press the
"SET" button twice to start setting refrigerator temperature.
• Press the "UP" button to increase the temperature in 1°C or 2°F increments.
• Press the "DOWN" button to decrease the temperature in 1°C or 2°F increments
• Press and hold the "SET" and "DOWN" buttons simultaneously for 5 seconds to select
the temperature unit (°C or °F)
DIVIDING THE FREEZER INTERIOR
The freezer compartment is supplied with a removable divider. This divider can be easily
removed by lifting it vertically. When refitted, the divider must be located between the
ribs on the sides of the freezer compartment.
USING THE COMPRESSOR COOLER
Ensure to place only the food that is designed to be stored at the temperature of the
compressor cooler.
In the left compartment, place the food that you would like to freeze. In the right
compartment, place the food and beverages you want to cool.
CLEANING AND MAINTENANCE
• WARNING: Always disconnect the device from the power supply before cleaning or
maintenance.
• Never immerse the unit in water or other liquids.
• Wipe interior and exterior with a damp cloth and neutral cleanser.
• Do not use abrasive cleaning agents or hard objects during cleaning as these can
damage the product.
EN
55