Publicidad
Idiomas disponibles
Idiomas disponibles
I I I . B AT T E R I E S A N D C H A R G I N G
Indicates that the battery in your scooter
has
been
United
Nations
standard UN38.3. We suggest you contact
the carrier's ticket counter in advance
to
determine
requirements, and to ensure your scooter
and its battery are permitted.
Indicates that the battery in your scooter
exceeds the maximum allowable Watt-hour
requirement for air travel.
How do I change the battery in my scooter?
MANDATORY!
purchased from an authorized Dealer. The
battery pack must not to be opened.
WARNING! Contact your Dealer if you have
any questions regarding the battery in your
scooter.
WARNING! Do not replace the battery while
the scooter is occupied.
WARNING! Do not pull on electrical lead
wires directly to detach them from the
scooter. Always grasp the connector itself
when disconnecting the lead to prevent
wire damage.
To remove/install the battery pack, see fi gure 10:
1. Ensure the manual freewheel lever is in drive mode.
See fi gure 5.
2. Ensure the key switch is switched to off . See fi gure 1.
3. Push breaker toward front of scooter. See fi gure 3.
4. Pull the battery release strap and lift the battery up and
off the scooter.
NOTE: Ensure the battery strap is kept outside the battery
compartment when installing or replacing the battery.
5. Align the tabs on the new battery with the alignment
holes. See fi gure 10.
6. Press down on the battery pack until you hear a "click."
7. Push breaker toward the rear of scooter. See fi gure 3.
NOTE: Do not place or store any items in the area of the
breaker to prevent accidental contact with the breaker.
NOTE: Contact your local waste disposal agency or
authorized Dealer for information on proper battery
disposal.
i-Go™
tested
and
complies
Transport
Regulations
that
carrier's
specifi c
All i-Go batteries must be
with
1. Battery Release Strap
Figure 10. Battery Removal/Installation
IDENTIFICATION KEY
15
Publicidad
