Pride Mobility i-Go S20 Manual Del Propietário página 21

V I . B A S I C T R O U B L E S H O O T I N G
What if all the systems on my scooter seem to be "dead"?
 Make certain that the circuit breaker is turned "ON" (toward the rear of the scooter).
 Check that the battery is fully charged.
 Make sure that the battery pack and its wires are connected tightly and correctly.
 Make certain that the battery pack is seated properly.
What if the scooter's battery won't charge?
 Ensure both ends of the charger power cord are connected properly.
What if the main circuit breaker repeatedly trips?
 If the main circuit breaker trips repeatedly, see your authorized Dealer for service.
 Charge the scooter's battery pack more frequently. See III. "Batteries and Charging."
 See III. "Batteries and Charging" or "Product Specifi cations Sheet" for information about your scooter's
battery type.
To check a fuse:
1. Remove the fuse holder by pressing in and turning one quarter turn
counterclockwise.
2. Examine the fuse in the fuse holder. See fi gure 18. If the fuse is
blown, it needs to be replaced.
3. Insert a new fuse of the proper rating into the fuse holder.
4. Reinstall the fuse holder by pressing in and turning one quarter
turn clockwise.
WARNING! The replacement fuse must exactly match
the rating of the old fuse. Failure to use properly
rated and approved fuses may cause damage to the
electrical system.
i-Go™
Figure 18. Fuse Replacement
21