Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions – LDSSQ4/LDSSQ6 Commercial Recessed LED Rough-In
7 .
Properly align the connector. Plug in the luminaire quick
disconnect on the module.
8.
Ensure the connector is properly engaged.
9.
Install the LED engine and trim assembly by inserting
the torsion springs into the spring receivers located
inside the housing (Figure 6).
Figure 5
Figure 6
Cleaning
To Clean Trims:
1.
Press in on white plastic latch to remove upper
reflector and clean lens. (Figure 7 & 8)
1.
Gently wipe with soft, clean, dry lint-free cloth to
remove dust.
2.
Wipe with mild detergent solution on a soft, clean cloth
to remove fingerprints and stains.
3.
Rinse with clean water and dry with soft, clean, dry
lint-free cloth.
Installation Instructions – LDSSQ4/LDSSQ6 Commercial Recessed LED Rough-In www.cooperlighting.com
Figure 7
Figure 8
Electrical Connection
CAUTION
Make certain no bare wires are exposed outside of lever nut
connectors.
1.
Provide electrical service according to the "National
Electrical Code" or your local electrical code to the
junction box (located on the plasterframe). Supply
wire insulation must be rated for at least 90°C. The
junction box is listed for (4) #12 AWG (two in, two out)
90°C conductors and feed thru branch wiring for type
IC and Plug in drivers for 120/277V only. For all other
cases (8) #12 AWG (four in, four out) 90°C conductors
and feed thru branch wiring for 120/277V only.
2.
Remove junction box cover (Figure 9).
3.
Remove appropriate round pryout and connect conduit
to junction box with proper connector (not included).
4.
Connect supply lead wires to junction box lead wires
(line, neutral and ground) in the fixture using the
provided lever nut connectors. (Figure 11). Be careful
not to leave any bare conductors outside of the lever
nut connectors.
5.
Lift the orange tab on the lever nut to disengage the
wire and close to secure the wire in place. (Figure 11).
6.
Connect white to white, black to black, and green
(from electrical service) on the supply side to the bare
copper wire in the junction box. Place all excess wiring
and connections into the junction box and replace the
cover. Place all connections and excess wiring into the
junction box and replace cover.
3
Publicidad
