AEG NSC7G751ES Manual De Instrucciones página 11

To deactivate the alarm, press the
freezer temperature button.
The alarm indicator and sound go off.
The freezer temperature indicator shows
H° for 5 seconds before indicating the
freezer temperature again.
The alarm restarts one hour
after deactivation until the
normal conditions are
restored.
If you do not press any
button, the sound switches
off automatically after
around one hour to avoid
disturbing.
4.11 Door open alarm
If the fridge door is left open for
approximately 5 minutes or if the freezer
door is left open for approximately 80
seconds, the sound is on and the door
open alarm indicator turns on. The
internal fridge light may also start
flashing.
The alarm stops after closing the door.
Press any button to switch off the sound
and flashing of the internal fridge light.
If you do not press any
button, the sound switches
off automatically after
around one hour to avoid
disturbing.
4.12 Setting mode
The Setting mode allows you to:
• Enable or disable the ECOMETER
indicator
• Enable or disable the button sounds
• Change the temperature units from °C
to °F
• Reset the control panel to factory
settings
Activating the Setting mode
To activate the Setting mode:
1. Press and hold the ECO button for
approximately 3 seconds. When the
Setting mode is being activated, the
display shows a blinking
2. Once the Setting mode is switched
on, the display shows
To deactivate the Setting mode, press
and hold the ECO button for
approximately 3 seconds.
The Setting mode deactivates
automatically if you do not interact with
the control panel for 60 seconds.
Navigating the Setting mode
1. Activate the Setting mode (refer to
"Activating the Setting mode").
The display shows
2. Tap the Fridge temperature button
(on the left) to change the parameter
and the Freezer temperature button
(on the right) to change the
parameter value.
Display
ECOMETER indicator
In order to switch the ECOMETER on or
off:
1. Activate the Setting mode (refer to
"Activating the Setting mode").
The display shows
2. Tap
show respectively
or
indicator.
3. Press and hold the ECO button for
approximately 3 seconds to exit the
Setting mode.
Button sounds
You can enable or disable the button
sounds in the Setting mode. To enable or
disable the sounds:
1. Activate the Setting mode (refer to
"Activating the Setting mode").
.
The display shows
.
ENGLISH
Default parame‐
ters
ECOMETER indica‐
tor
Button sounds
Temperature units
Factory settings
repeatedly. The indicator will
for the enabled
for the disabled ECOMETER
11
.
.
.