Publicidad
Idiomas disponibles
Idiomas disponibles
T R O U B L E S H O O T I N G
Fault
One or some of
my D-rings has
come unstuck or
has fallen off.
There is a bump on
the underside of my
board.
My SUP won't
fit back into the
backpack.
19
Inspection
Check whether you just
need to glue the D-ring
back on, or if you require a
new one.
A bump is clearly
visible on the bottom of
the board underneath
the valve.
The board is a very tight-
fit and doesn't appear to
fit back into the backpack.
Solution
Use a strong adhesive glue to re-apply the
D-ring, source a new D-ring from a supplier or
contact us for a replacement.
If the problem persists, please contact us at
sup-support@bluefintrading.co.uk
Additional resources may be found at www
bluefinsupboards.com/info-zone/maintenance-
repair/
Don't worry. This naturally occurs on every
paddle board. Sometimes it is covered by a fin
box or other detail, but is exposed on certain
models. It occurs due to a gap in the drop-stitch
to make space for the valve. It won't affect the
performance or quality of your SUP in any way.
Unfold the SUP and ensure that all of the air
has been squeezed out. You can crawl on the
board on your knees, or apply pressure by
as possible. Roll the SUP up in approximately
1ft increments and re-pack. For some larger
models, it may help to fold the sides inwards
before rolling.
If the problem persists, please contact us at
sup-support@bluefintrading.co.uk
Additional resources may be found at www.
bluefinsupboards.com/info-zone/maintenance-
repair/
Publicidad
