DeWalt DW677 Manual Del Usuario página 18

E N G L I S H
Also refer to the table below.
Conductor size (mm 2 ) Cable rating (Amperes)
0.75 6
1.00 10
1.50 15
2.50 20
4.00 25
Cable length (m)
7.5
Voltage Amperes Cable rating (Amperes)
115 0 - 2.0 6
2.1 - 3.4 6
3.5 - 5.0 6
5.1 - 7.0 10
7.1 - 12.0 15
12.1 - 20.0 20
230 0 - 2.0 6
2.1 - 3.4 6
3.5 - 5.0 6
5.1 - 7.0 10
7.1 - 12.0 15
12.1 - 20.0 20
Assembly and adjustment
Prior to assembly and adjustment always
unplug the tool.
Adjusting the depth of cut (fig. B)
• Turn the planing depth adjustment knob (4).
One revolution of the adjustment knob equals a
1.5 mm change in depth. One graduation
corresponds to a depth of cut of 0.1 mm.
Attaching and removing the parallel fence
(fig. A & C)
The parallel fence (12) is used for optimum tool
control on narrow workpieces.
• Slacken the wing bolt (6).
• Fit the parallel fence (12) in the hole (7) from
either side.
• Tighten the wing bolt.
• To remove the parallel fence, proceed in reverse
order.
Removing reversible cutters (fig. D)
• Loosen the three bolts (13) with the spanner (14)
supplied.
en - 4
All manuals and user guides at all-guides.com
15 25 30 45 60
6 6 6 6 10
6 6 6 15 15
6 10 15 20 20
10 15 20 20 25
15 20 25 25 -
20 25 - - -
6 6 6 6 6
6 6 6 6 6
6 6 6 10 15
10 10 10 15 15
15 15 15 20 20
20 20 20 25 -
• Flap the side guard (8) up.
• Slide the cutter (15) out of its holder.
• Reverse the cutter or replace it.
Always replace both cutters.
• Slide the cutter into the holder. Make sure that
the cutter is flush with the planing shoe (16).
• Tighten the three bolts (13).
Instructions for use
Always observe the safety instructions
and applicable regulations.
Prior to operation:
• Adjust the depth of cut.
• If necessary, fit and adjust the parallel fence.
Use sharp cutters only.
Switching ON and OFF (fig. A)
Your Planer is equipped with a safety switch to
prevent inadvertent operation.
• Switching ON: press the lock-off button (2) and
subsequently press the ON/OFF-switch (1).
• Release the lock-off button (2).
• Switching OFF: release the ON/OFF-switch (1).
Always switch OFF the tool when work is finished
and before unplugging.
Planing (fig. A)
• Switch the tool ON as described.
• Slowly move the Planer over the workpiece.
• The feed speed should not be too high,
especially when using the maximum
depth of cut and planing width.
• Remember that several shallow cuts are
better than one deep cut.
• Switch the tool OFF.
Your Planer is equipped with a parking shoe (11).
After switching OFF the tool can be put down
without waiting for the cutters to come to a
standstill.
14