Assembly And Adjustments - DeWalt D26676 Manual De Instrucciones

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal injury, turn
tool off and disconnect tool from power source before making
any adjustments or removing/installing attachments or acces-
sories. An accidental start-up can cause injury.
Adjusting the Depth of Cut
(Fig. 2)
Turn the planing depth adjustment knob (D).
One revolution of the adjustment knob equals
a 1.5 mm change in depth. Each click of the
adjustment knob represents 0.1 mm of depth,
and will increase up to 1.0 mm in depth.
Attaching and Removing
the Parallel Fence (Fig. 3)
The parallel fence (L) is used for optimum tool
control on narrow workpieces.
1. Loosen the wing parallel fence tightening bolt (F).
2. Fit the parallel fence (L) into hole (G) from either side.
3. Tighten the parallel fence tightening bolt.
4. To remove the parallel fence, proceed in reverse order.
FIG. 3
F
G
Removing the Blades (Fig. 4)
1. Remove the three bolts (M) with the spanner (N) supplied.
2. Push the side guard (H) up.
3. Remove drum cover (Q) and remove the blade (O) from its
holder.
FIG. 2 4. Sharpen or replace the blades. To sharpen blades, see
Sharpen Blades.
CAUTION: Risk of property damage. Always replace both blades.
D
5. Replace the drum cover (Q). Make sure the blade is flush with
the planing shoe (P).
6. Tighten the three bolts (M).
FIG. 4
N
H
Adjusting Blades (Fig. 5)
1. Place the blade (O) on the gauge (R), and make sure the blade
edge is perfectly flush with the inside edge of the gauge (R).
2. Place the bracket (S) on the blade, and make sure the flange of
L
bracket is flush with the back side of the gauge.
3. Tighten the two screws (T) on the bracket.
4. Place the flange of the bracket into the groove of drum (U).
5
M
O
Q
S
O
U
P
M