Efapel 40218 Instrucciones De Uso página 22

CONNECT THE BLIND'S COMMAND TO THE NETWORK -
1 STEP
ST
Press RESET 7 seconds
until all the LEDs are
at half brightness.
2 STEP
ND
Click on PROG.
3 STEP
RD
Click on
command button of
the Installation Key
(Ref. 40925) in close
proximity to
Blind's Command.
22
the
the
ONLINE
1.1 - The LED Up ( )
switches on.
2.1 - The LED Up ( )
starts to blink,
indicating that it is
ready to be added to
the network, during
a period of
seconds .
3.1 - The LED starts to
blink red, indicating
that it is searching for
the device that is going
to be added.
3.2 - The LED blinks
green and switches off,
the device's LED Up (
) switches off and
the A, B, D, C LEDs
switch on and off, in
sequence, indicating
that the Blind Com-
mand was successfully
added to the network.
Note: If the Installation Key LED
does not turn green and switch
off, repeat from the 1 step.
st
10