Caberg FLIP-UP DUKE EVO Manual De Instrucciones página 7

5. HOW TO REMOVE THE WASHABLE INNER LINER
You can start to remove the internal padding from either the right or left cheek.
5.1 With the chin guard raised, remove the cheek pad by releasing the
snap fasteners on the back. Then repeat for the other side (Pic. 9).
5.2 Extract the cheek pad by pulling it from the chin strap through the slot. Then repeat for the
other side.
5.3 Starting from the neck protection, release the lining by pulling slightly towards the inside of
the helmet (Pic. 10).
Still pulling slightly, detach the front fixing strips from the support fixed to the shell.
5.4 Remove completely the liner.
CLEANING THE WASHABLE LINING!
• Scrub by hand with neutral soap and water (max 30° C).
• Rinse with cold water. Do not wring. Dry at room temperature.
CAUTION! Never wash the lining in the washing machine. Never use petrol or other solvents to
clean the lining.
6. HOW TO FIT THE WASHABLE INNER LINER
6.1 Place the main inner padding inside the helmet.
6.2 Insert the left fixing flap C in the support seating right below the chinstrap (Pic. 11).
Repeat the operation for the right-hand fixing strip.
6.3 Insert and attach the front strips into the seat on the support fixed to the polystyrene inner
shell (Pic. 12).
6.4 Insert the strips in the neck area between the polystyrene inner shell and the outer shell
(Pic. 13).
6.5 Insert the chin strap in the slot of the cheek pad. Repeat for the other cheek.
6.6 Attach the cheek pads by pressing the snap fasteners on the back (Pic. 9).
STOP WIND
The wind deflector limits the inflow of cold air from below.
7. STOP WIND ASSEMBLY INSTRUCTIONS
7.1 Insert and press in the centre of the wind deflector fastening frame between the edge of the
shell and the chin guard. (Fig.14)
8. STOP WIND REMOVAL INSTRUCTIONS
8.1 The wind deflector is removed by pulling it upwards. (Fig. 15)
CAUTION! You must always stop your bike before opening/closing the chin guard.
ENG
7