CycloVac HD Serie Manual De Instrucciones página 11

Collector with electrostatic Bag
replace the bag when full. frequency will depend
on use of the unit.
1. to access the bag, unlatch the two clips and
remove the dust receptacle (figure 16).
2. remove the used bag and seal bag opening
(adhesive seal provided on each bag). Discard
used bag.
3. Install the new bag, ensuring the tabs on the
bag adaptor are aligned with the slots in the bag
collar (figure 17).
4. ensure adequate sealing by inserting bag as far
as retention ring (figure 18).
rotate bag 20° (figure 18) to ensure tabs on
bag adaptor are no longer aligned with the slots
in the bag collar.
5. put the dust receptacle back in place and seal
by latching both clips.
Only use genuine Cyclo Vac replacement bags.
Failure to do so could void the warranty on
your collector.
the drum-shaped filter requires no maintenance. It will be checked by the
authorized dealer when you have the system unit inspected, after approximately
500 hours of use.
Permanent Filter
troubleshooting
figure 16
retention ring
tabs on bag adaptator
figure 17
figure 18
11