Publicidad
Idiomas disponibles
Idiomas disponibles
Other possible errors and their solutions
If problems occur when using the device, the following points should be
checked:
Malfunction
The display remains blank when the
instrument is switched ON although
the batteries are in place.
The pressure does not rise although
the pump is running.
The device frequently fails to measure
the blood pressure values, or the val-
ues measured are too low or too high.
Every measurement results in different
values, although the device functions
normally and normal values displayed.
The blood pressure values differ from
those measured by my doctor.
After the instrument has inflated the
cuff the pressure falls very slowly or
not at all. (No measurement possible).
Remedy
• Check battery installation.
• If the display is unusual, remove the
batteries and then exchange them
for new ones
• Check polarity
• Check the connection of the cuff
tube and connect properly.
• Fit the cuff correctly on the arm. (see 5.3)
• Before starting the measurement
make sure that the cuff is not too
tight and that clothing is not exert-
ing pressure on the arm. Take off
articles of clothing if necessary.
• Measure blood pressure again in
complete peace and quiet.
• Please read the following informa-
tion and the points listed under
"Common sources of error".(5.2)
Repeat the measurement.
• Blood Pressure changes constantly.
The observed readings may accu-
rately reflect your pressure.
• Record daily values and consult your
doctor.
• Pressure readings in your doctor's
office may be higher due to anxiety.
• Your blood pressure fluctuates
throughout the day so record the
time along with your reading.
• Check cuff connections.
• Ensure the unit has not been
tampered with.
23
Publicidad
