Publicidad
Idiomas disponibles
Idiomas disponibles
Introduction
WARNING:
safety chapter before you use the product.
To do a function check before you use
the product
1. Do a check of the air inlet for dirt and cracks. Use
a brush and clean off grass and leaves from the
product.
2. Make sure that the product works correctly.
3. Do a check of all nuts and screws and make sure
that they are tight.
Battery
WARNING:
you must read and understand the safety
chapter. You must also read and understand
the operator's manual for the battery and the
battery charger.
Keep the battery and the battery charger in correct
ambient temperatures.
Ambient temperature
Operation of the bat-
-20 ºC – 50 ºC
tery in the product
Charging of the bat-
0 ºC – 35 ºC
tery
To charge the battery
Charge the battery before the first use.
Note:
The battery does not charge if the battery
temperature is more than +35 °C.
1. Connect the power cord for the battery charger in a
grounded mains.
CAUTION:
mains has the correct voltage and
frequency.
2. Put the battery in the battery charger. The battery
is connected to the battery charger when the green
LED flashes. (Fig. 24)
3. The battery is fully charged when the green LED
on the battery charger is on. Charge the battery for
maximum 24 hours.
314
Operation
Read and understand the
Before you use the battery,
Make sure that the
4. Disconnect the battery charger from the mains.
CAUTION:
cord.
5. Remove the battery from the battery charger.
Battery status LED on the battery charger
The red LED (A) and the green LED (B) on battery
charger show the battery status. Refer to
charger on page 316 .
(Fig. 25)
LED
The green LED flashes
quickly.
The green LED flashes
slowly.
The green LED is on.
The red LED is on.
The red LED flashes
quickly.
Battery status LED on the product
When the battery is installed in the product, the LEDs on
the product show the battery status.
(Fig. 26)
LED
Battery status
LED 1, 2 and 3 are
Fully charged.
lit.
LED 1 and 2 are lit.
Sufficiently charged
LED 1 is lit.
The battery power is low.
LED 1 flashes.
The battery is empty. The bat-
tery status indicator flashes.
Charge the battery. Refer to
charge the battery on page 314 .
To connect the battery to the product
WARNING:
products of the POWER FOR ALL system
18V.
1. Make sure that the battery is fully charged.
Do not pull the power
Battery
Battery status
The battery is charging.
The battery is 80% charg-
ed.
The battery is fully charg-
ed.
Battery charger
Refer to
on page 316 .
Battery charger
Refer to
on page 316 .
To
Only use the battery with
1876 - 003 - 27.09.2022
Publicidad
