Whispbar K325W Instrucciones De Montaje página 13

EN
Fitting Kit
K325W
Position crossbar so hole in centre of metal
loadplate lines up through packer block
with threaded insert in fixed-point. If
standing on the right side of vehicle, use
hole marked "R". If on the left use hole
marked "L".
Tighten adjusting screw to 5 Nm (3.7 ft lb)
hand tight.
When fitting type B crossbars, tighten using
Hex Key located inside one of the right
hand side covers to assist.
Using long capscrew and washer, secure
assembly onto leg (use Hex Screwdriver
supplied with crossbar to assist).
Check crossbar is securely attached to the
vehicle.
Use keys to fit and lock covers
13